Filter
Top Products
When cutting crown and cove moldings, set the bevel angle and miter angle as indicated
in the table (A) and position the moldings on the top surface of the saw base as indicated
in
the table
(B).
Table (AI
Bevel angle
52/38''
type
45O
type
Molding position
in Fig. (C)
Miter angle
45'
type
52/38''
type
For inside corner
Left
33.9O
(3)
Left
30'
Right
31.6"
Right
35.3'
Wall contact edge should be
against guide fence.
Molding
pos'tion
in Fig (C)
1
li,
Molding edge against guide fence
Ceilinq contact edqe should be
Finished piece
(Example)
In the case of cutting
52/38'
type crown molding for position
0
in Fig. (C):
*Tilt and secure bevel angle setting to
33.9O
LEFT.
*Adjust and secure miter angle setting to
31.6O
RIGHT.
*Lay
crown molding with its broad back surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the saw.
*The finished piece to be used will always be on the
LEFT
side of the blade after the
cut has been made.
I
against guide fence.
I
l?i
For inside corner
21
Finished piece will be
on
the
Left side of blade.
For outside corner
a
Ceiling contact edge should
be
against guide fence.
Finished piece will
be
on the
Right
side
Of
blade'