Filter
Top Products
Make sure that the pointer on the arm
points to
0"
on the bevel scale on the
arm holder.
If
it does not point to
0",
loosen the screw which secures the
pointer and adjust the pointer
so
that
it
will
point to
0".
ii) 45" bevel angle
Adjust the 45" bevel angle only after
performing
0"
bevel angle adjustment.
To
adjust left 45" bevel angle, loosen
the lever and tilt the blade 45" to the
left. Make sure that the pointer on the
arm points to 45" on the bevel scale
on the arm holder. If the pointer does
not point to 45", turn the 45" bevel
angle adjusting bolt (upper bolt) on the
right side of the arm until the pointer
points to 45".
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
to the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced at
the same time. Use only identical carbon
brushes.
/
45"
bevel angle adjusting bolt
/
Limit mark
27