Filter
Top Products
12.11 Feed Gear Clutch
Push clutch lever down to disengage
the feed gear clutch.
Set cutterblock guard against the
fence and lock in position. Max.
permissible opening between fence
and guard extrusion is 8 mm.
Set guard assembly to workpiece
thickness by turning the starknob
setting screw as required. Stock up to
60 mm thickness is always passed
underneath the cutterblock guard.
When feeding the hands glide over
the cutterblock guard.
Set fence forward so that the fence carrier extrusion covers the cutterblock, to
expose only the width of the workpiece.
Set machine up for planing. Swing
cutterblock guard assembly in position
and connect machine with suction
hose to a dust collector.
13.2 Planing/Surfacing Flat Stock
13 Operation
13.1 Ticknessing
Set up machine for thicknessing as described in para 12.8 and connect with suction hose to a dust collector.
Set thicknesser bed to desired
workpiece thickness.
Start machine and engage feed gear
clutch.
Place workpiece with the already
planed side facing down onto the
thicknesser bed and slide forward until
the infeed feed roller gets hold of it.
The workpiece is now automatically fed through the thicknesser and has to be received by the operator on the outfeed
side of the machine. Stock longer than 1.6/1.7 meter requires additional support.