Filter
Top Products
OM-230 009 Page 14
. The illustration shows remote control connected through the wirefeeder.
The wirefeeder is not connected to the power source output..
5-2. Typical Connection Diagram For TIG Equipment
804 779-A
! Do not mount feeder on top of pow-
er source.
! Do not put feeder where welding
wire hits cylinder.
! Do not move or operate equipment
when it could tip.
1 Welding Power Source
2 Gas Cylinder
3 Gas Hose
4 Positive (+) Weld Cable
5 Negative (−) Weld Cable
6 Torch
7 Workpiece
8 Foot Control
9 Wire Feeder
10 14-Pin Feeder Control Cable
11 Remote Switch To STICK/TIG
12 Volt Sense Receptacle
(Cable Disconnected)
. Maximum cable length not to exceed
150 feet.
1
4
9
10
8
2
6
7
5
3
12
11