Filter
Top Products
14
BLADE SAFETY
WARNING
§ ALWAYS inspect diamond blades before each use. The blade
should exhibit no cracks, dings, or flaws in the steel centered core
and/or rim. Center (arbor) hole must be undamaged and true.
§ Examine blade flanges for damage, excessive wear and
cleanliness before mounting blade. Blade should fit snugly on the
shaft and against the inside/outside of the saw.
§ Only cut the material that is specified by the blade. Read the
specifications of the blade to ensure the proper tool has been
matched to the material being cut.
§ ALWAYS keep blade guards in place. Exposure of the blade must
not exceed 180 degrees.
§ Ensure that the blade does not come into contact with the ground
or surface during transportation. DO NOT drop the blade on the
ground or surface.
§ The engine governor is designed to permit maximum engine
speed in a no-load condition. Speeds that exceed this limit may
cause the blade to exceed the maximum safe allowable speed.
§ Ensure that the blade is mounted for proper operating direction.