Filter
Top Products
53
Lubrication
This saw has five grease fittings on the front axle assembly.
• Front axle pivot bearings (F1 & F3)
• Hydraulic lift cylinder ends (F2, and far end of cylinder)
• Depth Stop Pivot Plate (F4)
These fittings are easily accessed by raising the saw half way up, and then lifting
the rear of the saw until the blade collars rest on the ground.
WARNING
To prevent the possibility of crush injury, ensure that the saw is
securely placed on blocks before servicing the lubrication points.
CAUTION
Grease fittings every 50 hours of operation with a premium grade
waterproof E. P. (extreme pressure) grease.
Fig. 35 — Grease Fittings and Maximum Cut Depth Stops (view from back of saw)
F3
F2
F1
Maximum Cut Depth
Stop Bolt
Maximum Cut Depth
Stop Bolt
F4