Filter
Top Products
66
SPECIFICATIONS
Engine
57 HP Turbocharged Deutz Diesel, direct injection, air/oil cooling, oil filter and
above-frame remote oil drain.
Engine Air Cleaner
4-Stage air filtration, pre-cleaner plus cartridge element and safety element.
Fuel Tank
10 Gallon clear-molded plastic fuel tank with sight gauge, central drain and
shutoff valve.
Blade Shaft Assembly
Fully enclosed transmission, bearings and shaft, oil bath lubrication with cooled
and filtered oil circulation system, 4 protected shaft seals, 2-3/8” diameter blade
shaft, rack & pinion shifting, positive shift lock, oil sight gauge, magnetic drain
plug, easy serviceability, remote protected oil fill and vent, blade usable on either
side of saw, taper lock blade collar attachment, standard blade shaft tachometer,
ratios of 1:1, 1.34:1, 1.7:1, and 2.02:1
Blade Collars
Plated quick-disconnect, taper lock attachment, 5.5” diam., 24 water spray ports.
Blade Flushing
Minimum water usage system, evenly distributed across the blade, panel-
mounted flow control.
Blade Range
14” to 48”.
Max Cut Depth
21”.
Blade Guard
Extra heavy design, slip-on type with double lip seal and quick disconnect water
hose, two handles.
Blade Shaft Drive Belt
Dual 5--Groove premium quality Goodyear HY-T Wedge Torque Team belts.
Blade Control
12-Volt hydraulic raise/lower system, 3 blade plunge speeds, fast and slow blade
plunge speed buttons on joystick, raise button on joystick, one-hand control.
Blade Depth Stop
Positive, heavy-duty hydraulically controlled depth stop.
Balance
Front steer.
Handlebars
3-Position adjustable angle, storage position, quick locks.
Front Wheels
8” x 3”, precision sealed bearings in each wheel with extra end seals and seal
protectors, no grease points.
Rear Wheels
12” x 3”.
Drive System
Hydrostatic powered transaxle with infinite speed control, joystick control, remote
oil filter and up to 300 feet per minute travel speed. Locked axle drive.
Engine Controls
Twist-lock throttle, backlit tachometer with hour meter, voltmeter, oil pressure
gauge and 3-position ignition switch.
Battery
12-Volt, group 75, 1000 cold cranking amps.
Front Pointer
Heavy gauge steel, 6” pointer wheel and plastic-coated tether.
Rear Pointer
Standard, adjustable.
Hardware
Grade 8 fasteners throughout.
Tools
15/16” Blade wrench.
Dimensions
L= 47-1/2” with handlebars stored, W = 32” w/o blade collars, H= 44” with front
pointer up.
Weight
1,700 Pounds, with oil but no fuel.
Serviceability
Spin-on oil filters, lubrication points, lube every 50 hours.