Patton electronic 2603 Router User Manual


 
13
About this guide
This guide describes installing and configuring Patton Electronics IPLink Series High Speed Routers. The
instructions in this guide are based on the following assumptions:
The router may connect to a serial DTE device or T1/E1 line
There is a LAN connected to the Ethernet port of the router
Audience
This guide is intended for the following users:
Operators
Installers
Maintenance technicians
Structure
This guide contains the following chapters and appendices:
Chapter 1 on page 17 provides information about router features and capabilities
Chapter 2 on page 24 contains an overview describing router operation
Chapter 3 on page 27 provides initial configuration procedures
Chapter 4 on page 40 describes configuring the Ethernet LAN interface
Chapter 5 on page 44 describes configuring the serial WAN interfaces
Chapter 6 on page 50 describes configuring WAN services
Chapter 7 on page 68 describes configuring security for the router
Chapter 8 on page 82 describes DHCP and DNS configuration
Chapter 9 on page 93 describes configuring IP services
Chapter 10 on page 96 describes system configuration
Chapter 11 on page 104 describes SNTP client configuration
Chapter 12 on page 108 provides a summary of the IPLink’s status webpage and status LEDs
Chapter 13 on page 112contains information on contacting Patton technical support for assistance
Appendix A on page 115 contains compliance information for the IPLink routers
Appendix B on page 118 contains specifications for the routers
Appendix C on page 122 provides cable recommendations
Appendix D on page 124 describes the router’s ports
Appendix E on page 129 describes how to use the command line interface (CLI)
For best results, read the contents of this guide
before
you install the router.