Filter
Top Products
WAN Serial Port Configuration 46
Models 2603, 2621, and 2635 Getting Started Guide 5 • Serial Port Configuration
Web Interface Configuration
The following screen capture shows the variables available to configure the X.21 serial interface.
Figure 21. Model 2621 X.21 serial port configuration parameters
The next figure shows the Model 2635 (V.35) serial port configuration parameters.
Figure 22. Model 2635 V.35 serial port configuration parameters
After the serial port has been configured, go to “WAN Service Configuration” on page 52 section “WAN Ser-
vice Configuration” on page 52 for router/bridge and WAN service configuration.
T1/E1 Interface Configuration
The IPLink Series Model 2603 is equipped with a user selectable T1/E1 interface. The T1 interface is pre-
sented on an RJ-48C (100-ohm) connector, while the E1 interface can use the RJ-48C (120-ohm) or dual
BNC (75-ohm) connectors.
The 2603 T1/E1 serial port configuration page appears in figure 23.