Filter
Top Products
6
MOVING CUTTINGHEAD
TO THE REAR POSITION
1. MAKE CERTAIN THE MACHINE IS DISCON-
NECTED FROM THE POWER SOURCE.
2. Carefully remove cable tie (A) Fig. 4, which is
holding the cuttinghead in the down position.
3. To move the cuttinghead (D) Fig. 5, to the rear
position, loosen lock knob (E) and push cuttinghead (D)
to the rear position. Then tighten lock knob (E) Fig. 6.
4. Fig. 6, illustrates the cuttinghead locked in the rear
position.
RAISING THE CUTTINGHEAD
1. While holding the cuttinghead (A) Fig. 7, down, pull
out and rot ate cuttinghead lock knob (B) 90 degrees
until pin (C) Fig. 8, is in the horizont al position as shown.
The cuttinghead can then be raised.
2. Fig. 9 illustrates the cuttinghead (A) in the raised
position.
3. W ARNING: Cutterhead lock knob (B) Fig. 7, is
designed to lock the cutterhead in the down position for
only storage or carrying. Never operate saw with the
cutterhead in the lock down position.
Fig. 5
D
Fig. 4
A
Fig. 6
Fig. 7
B
Fig. 8
C
Fig. 9
A
E
E
B
A