Filter
Top Products
7
ASSEMBLY
W ARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWER
SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ A N D
UNDERSTOOD THE ENTIRE OWNER S MANUAL.
ASSEMBLING DUST ELBOW AND DUST BAG
1. Insert smooth end of dust elbow (A) Fig. 10, into opening (B). The dust elbow (A) can be rotated as desired.
2. Compress spring clips (C) Fig. 11, on dust bag (D) and clip dust bag onto end of elbow (A) as shown.
MOVING TABLE TO THE 0 DEGREE CUT-OFF POSITION
1. Rot ate locking knob (A) Fig. 12, counterclockwise to unlock. Depress lever (B) and rotate table (C) to the 0
degree straight cut-off position, release lever (B) and tighten locking knob (A).
2. Fig. 13, illustrates the t able (C) in the 0 degree straight cut-of f position.
3. For proper operation and adjustment of the table, refer to sections, R O TA TING TABLE FOR MITER
CUTTING , ADJUSTING CLAMPING ACTION OF TABLE LOCKING MECHANISM and ADJUSTING
SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.
Fig. 10
A
Fig. 11
C
B
D
A
Fig. 12
A
B
Fig. 13
C
C