Filter
Top Products
10-3-3
STATOR
Holding the rear bracket and stator, fit them to
the front bracket. Match the mounting hole
of
the rear bracket and that of the rotor bearing,
and softly strike the outside periphery
of
the rear
bracket with a plastic hammer.
(See Fig.
10-31.)
Attach the stator cover around the stator.
Tighten the three
M6
boll
et to the front bracket .
TIGHTENING TORQUE
4.0
-
5.4
ft
Ibs.
535
-
735
N
cm
55
-
75kg-cm
i
to fix the rear brack-
Fig.
10-31
(4)
Put the grommet in the groove of the rear bracket and secure the wire.
Note
:
Fix
the
wire
from
the stator and diode stack with the
clamp
at
the
bottom
of
the groove.
10-3-4
CONDENSER
Put condenser to rear cover.
5
0
X
10
mm tapping Screw ----..----*.----..
2
pcs.
TIGHTENING TORQUE
2.4
-
4.0
ft
-
Ibs.
325
-
535
N
cm
55
kg
cm
Condenser
Fjg.
10-32
-43-