Filter
Top Products
10-3-5
END COVER
"
Set the end cover
on
the rear bracket with four
M5
X
10
screws.
10-3-6 BRACKET (COVER)
Mount the bracket (cover)
on
the rear bracket and
secure them with
M8
X30
bolts.
Fig.
10-33
10-3-7
FUEL TANK AND FUEL
PIPE
(CONNECTION)
(1)
Connect the rubber pipe to the engine carburetor and fasten
it
with a hose clamp.
Attach the banjo to the opposite end
of
the rubber pipe, tighten it with a hose clamp, and fasten the
pipe to the fuel strainer with the banjo bolt.
Note
:
Mount the fuel strainer with the banjo outlet upward.
(2)
Fasten the strainer to the front bracket with the joint nuts.
_-
(3)
Secure the mounting tab on the bottom of the fuel tank and the blower housing with
M6
X12
bolts.
Insert the attaching bolts
on
the other end of tank into the mount bracket hole and
secure
it with two
M8
nuts.
(4)
Connect the rubber pipe
First, fit the hose clamp
on
the rubber pipe, connect the strainer and fuel tank, then fasten the rubber
pipe with the hose clamps.
Note :Apply a drop of oil to the rubber pipe
so
that it may easily be connected to the strainer and the
fuel tank.
10-3-8 FUEL TANK HANDLE
(1)
Match
the
handle hole with the bolt
on
the top of the fuel tank and secure it with M8 nuts.
(2)
Completely insert the breather pipe over the bolt.
Note
:
There is
a
hole at the center of the breather pipe for air bleeding. Set the breather pipe
so
that the
hole
is
directed upward.
(3)
Fix both ends of the handle cover with
M3
X
10
screws.
-
44
-