Page 14
ASSEMBLY
Remove the table saw base, loose parts, and hardware from
the packing materials. Check all items with the loose parts
list and drawing. If you are unsure about the description of
any part, refer to the drawing. If any parts are missing, delay
assembling until you have obtained the missing part(s).
ASSEMBLING WHEELS AND HUB CAPS
See Figures 7 and 8.
Remove the following hardware from the bag:
2 wheels
2 hub caps
4 flat washers
2 shoulder bolts
Place the table saw on end. Secure the axle in place by
inserting a screwdriver or large nail in the hole in the
center of the axle.
See Figure 7.
Loosen bolts on each side of the axle by turning counter-
clockwise.
Note: To prevent the axle from slipping through the slots
on the table saw, do not remove both bolts at the same
time.
Place a wheel and two washers on the shoulder bolt in the
following order: washer, wheel, washer
Insert the shoulder bolt, wheel, and washers combination
into the axle. Securely tighten.
Place the hub cap in the holes in the wheel and tap the
hub cap into place.
Note: The short bolts removed from the axle should be kept
for future use if wheels are removed. There must always be
bolts in both sides of the axle for safe operation.
ASSEMBLING BUMPERS
See figure 9.
Place saw table on end as shown in figure 9.
Align the holes in the bumper with the holes in the side
of the saw.
Securely tighten bumpers in place using the screws.
Fig. 7
Fig. 8
SCREWDRIVER
WHEEL
WASHER
SHOULDER
BOLT
WRENCH
Fig. 9
SCREW