Filter
Top Products
Page 17
TO INSTALL RIP FENCE
See Figure 12.
To install the rip fence, place the rear lip on the rear rail and
pull slightly toward the front of the unit. Lower front end onto
the guide surfaces on top of the front rail. Check for a smooth
gliding action. Swing the locking handle down to automatically
align and secure the fence.
REMOVING/REPLACING THE THROAT PLATE
See Figure 13.
WARNING:
Make sure the switch is off and the plug is out of the outlet.
Failure to do so could result in accidental starting, result-
ing in serious personal injury.
WARNING:
Drop blade below saw table when reinstalling the throat
plate. Failure to heed this warning could result in serious
personal injury.
To remove the throat plate, first remove the screw holding
the throat plate with a phillips screwdriver.
With a finger in the finger hole, lift the front end of the
throat plate. Firmly pull the throat plate out toward the
front of the saw.
To reinstall the throat plate, drop blade below saw table
and place throat plate in the opening. Push throat plate
toward the rear of saw base to engage the spring clip.
Snap the throat plate in place.
Insert the throat plate screw and securely tighten.
ASSEMBLY
RIP FENCE
FRONT
RAIL
Fig. 12
THROAT
PLATE
SCREW
Fig. 13
FINGER
HOLE