Ryobi bts20r Saw User Manual


 
Page 16
ASSEMBLY
CLOSING THE LEG STAND
See Figure 11.
Note: You can also refer to the blue label on the top of the
table saw for tear-down procedures.
Standing to the side of the table saw, grasp the table tilt
handle with your left hand. Tilt the table saw to the your
left and grab the grip with your right hand. Gently lower
the table saw on its side.
See 1 and 2.
With your right hand on the grip, use your left hand to
release the leg stand latch.
See 3 and 4.
Once the leg stand is released from the table saw base,
ease the legs of the leg stand toward the floor.
See 5.
Place your right hand palm up near the bumper and lift the
lower leg of the leg stand up until it locks into place.
See
6 and 7.
Fig. 11