Ryobi bts20r Saw User Manual


 
Page 15
ASSEMBLY
OPENING THE LEG STAND
See Figure 10.
Note: You can also refer to the blue label on the right-hand
side of the table saw for setup procedures.
Standing to the side of the table saw, use your left hand
to pull the leg stand latch towards you.
See 1.
Once the leg stand is released from the table saw base,
ease the legs of the leg stand toward the floor.
See 2
.
Grasp the grip firmly with your right hand. Keeping your
left hand clear of the leg stand, pull the leg stand up until
it locks into place.
See 3 and 4.
With your left hand firmly on the table tilt handle, grasp the
grip with your right hand.
See 5.
Push the leg stand towards the ground with your right
hand and pull in the same direction with your left hand
until the table saw is in an upright position.
See 6 and 7.
Fig. 10