Filter
Top Products
switchboxwhenturningtherouterONor OFF.DO
NOTtouchanythingbuttheswitchboxwhendoing
this.NEVERreachundertheroutertableforanyrea-
sonwhentherouterisrunning,exceptto turnit OFF.
I
A
I
24.[ WARNING J Before making any cut, make
sure the router is turned OFF, the router bit is not
rotating, and the power cord is unplugged from the
electrical outlet. Then, make absolutely sure that the
overhead guard clears the router bit and the work-
piece. A trial pass, with the router turned OFF and the
router bit not turning, is strongly recommended.
25.l _WARNINGJ Never leave the router table
unattended while the router is running. Turn the router
OFF before leaving the router table for any reason.
26. If ANY of the parts is missing, DO NOT attempt
to assemble, install, or use your router table until the
missing parts have been found or replaced and your
router table has been properly and correctly assem-
bled per this manual.
27.[ _L, DANGER JNever use the floor stand as a
/ I
ladder and DO NOT stand on the router table.
Your Craftsman Router Table comes with the following:
• A unique 4" high unitized fence with fence guides that
provide parallel movement.
• Rulers molded into the table top that provide fast
and accurate fence adjustment for making the
following items:
- Tenons
- Sliding dovetail joints
- Tongue & groove joints
- Face cuts
• The unique fence also allows you to perform these
additional routing operations:
- Veining
- Fluting
- Making crown molding
- Making cuts up to 2-1/2" from the edge of the
workpiece toward the center of the workpiece
• A specially designed push block with a quick clamp
that can clamp work pieces up to 4" wide, for end grain
or edge routing.
• An accurate jointing fence that is quickly adjustable to
the proper depth of cut.
• A dust collector port on the fence to which most 2-1/2"
wet/dry vac hoses can be attached.
9-26478 Craftsman Router Table Floor Stand,
places router table at a convenient working height,
has adjustable floor levelers, and two steel shelves
for storage.
9-25468 Craftsman Guide Master RouterTable Push
Shoe, aids in push shoe and hold down operations,
accurate measurement and router table set-up,
transforms into a miter gauge, and gives quick set-up
for 1/2" sliding dovetail joints.
9-25333 Craftsman Industrial Router Adapter Plate,
for mounting non-Craftsman 1/4" and 1/2" reuters to
the router table. The holes for mounting the router
must be located and drilled by the user. The fasteners
for mounting the router to the adapter plate are not
included and must be obtained separately.
9-26478 Craftsman Router Table Floor Stand,
places router table at a convenient working height,
has adjustable floor levelers, and two steel shelves
for storage.
Refer to Parts List on page 19.
• /AI[jIAWARNINGj If ANY of the parts is missing,
DO NOT attempt to assemble, install, or use your
router table until the missing parts have been
found or replaced, and your router table has been
properly and correctly assembled per this manual.
• Contact your local Sears Retail Outlet for missing or
replacement parts.
• In order to simplify handling and to minimize any
damage that may occur during shipping, your router
table comes unassembled.
• Separate all parts from the packaging materials and
check each part against the illustrations and
the parts list at the end of this manual, to make
sure that all parts have been included. Do this before
discarding any of the packaging material.
5