Filter
Top Products
FIGURE 5 FIGURE 7
Front of--.
Router
Table
#10-32 Hex "Keps"_
Nut, (Typical)_ -_,- _ / Router
_ _ ,_/ / Table
_,_ _ --///_ \\/ Leg
Switch_ "_
#10-32 518" Long
Truss Head Machin
Screw, (Typical)
MOUNTING ROUTER TO THE ROUTER TABLE
I WARNINGI ALWAYSUNPLUGROUTER
BEFORE MOUNTING.
Craftsman Routers with Three-Hole and 6"
Diameter Base Plates
1. Remove the router base plate (back plate) from the
router.
2. Store the screws and the base plate in a convenient
location.
3. While holding the router upside down, position the
router against the bottom of the router table as shown
in Figure 6. Rotate the router until the three threaded
holes in the router base line up with the three corre-
sponding countersunk holes in the top of the router
table. (The router handles should be oriented as shown
in Figure 6.)
FIGURE 6
_ #10-32 x 518" Long
i _ Flat Countersunk
i _ i Head Machine
Y ! Screw
'_ '_ '_ w/Phillips Recess
2. Store the screws and the base plate in a convenient
location.
3. While holding the router upside down, position the
router against the bottom of the router table as shown
in Figure 8. Rotate the router until the three threaded
holes in the router base line up with the three corre-
sponding countersunk holes in the top of the router
table. The holes will line up in ONE position only.
(The router handles should be oriented as shown in
Figure 8.)
4. Insert three 5/16-18 x 1-1/4" long flat countersunk
head machine screws through the three holes in the
table top, as shown in Figure 9, and thread them into
the threaded holes in the router base housing.
5. TIGHTEN the screws SECURELY to the router.
FIGURE 8
i
FIGURE 9
4. Insert three #10-32 x 5/8" long flat countersunk head
machine screws through the three holes in the table
top, as shown in Figure 7, and thread them into the
threaded holes in the router base housing.
5. TIGHTEN the screws SECURELY to the router.
Craftsman Router Models 9-27500, 9-27510,
and 9-27511
1. Remove the router base plate (back plate) from the
router.
x 1-1/4" Long
Flat Countersunk Head
i Machine Screw
', w/Phillips Recess
7