Filter
Top Products
11
4
3
2
0
4
5
5
0
3
0
2
2
1
5
ASSEMBLY
Fig. 4
INNER
BLADE WASHER
OUTER
BLADE WASHER
LOWER BLADE
GUARD HANDLE
BLADE SCREW
BLADE
SPINDLE
SPINDLE
LOCK BUTTON
INSTALLING BATTERY PACK
See Figure 3.
NOTE: Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to
page 13, “CHARGING BATTERY PACK” for charging
instructions.
n Place battery pack in your saw. Align raised rib on
battery pack with groove inside saw, then slide battery
pack in saw as shown in figure 5.
n Make sure the latches on each side of your battery
pack snap into place and battery pack is secured in
saw before beginning operation.
CAUTION: When placing battery pack in your saw,
be sure raised rib on battery pack aligns with groove
inside saw and latches snap into place properly.
Improper assembly can cause damage to saw and
battery pack.
BATTERY PACK
LATCHES
Fig. 3
ATTACHING BLADE
See Figure 4.
WARNING: A 5-1/2 in. (140 mm) blade is the max-
imum blade capacity of your saw. Never use a blade
that is too thick to allow outer blade washer to en-
gage with the flats on the spindle. Larger blades will
come in contact with the blade guard, while thicker
blades will prevent blade screw from securing blade
on spindle. Either of these situations could result in a
serious accident.
n Remove battery pack from saw.
n Locate latches on side of battery pack and depress to
release battery pack from your saw.
n Remove blade wrench (6 mm hex key) from storage
area.
n Depress spindle lock button and remove blade screw
and outer blade washer.
NOTE: Turn blade screw clockwise to remove.
n Wipe a drop of oil onto inner blade washer and outer
blade washer where they contact blade.
WARNING: If inner blade washer has been re-
moved, replace it before placing blade on spindle.
Failure to do so could cause an accident since blade
will not tighten properly.
n Fit saw blade inside lower blade guard and onto
spindle.
NOTE: The saw teeth point upward at the front of saw
as shown in figure 3.
n Replace outer blade washer.
n Depress spindle lock button, then replace blade screw.
Tighten blade screw securely.
NOTE: Turn blade screw counterclockwise to tighten.
n Return blade wrench to storage area.
NOTE: Never use a blade that is too thick to allow the
outer blade washer to engage with the flats on the
spindle.