Filter
Top Products
14
OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
®
CHARGER
BATTERY PACK
SHOWN IN CHARGER
RED LED ON INDICATES
FAST CHARGING MODE
YELLOW AND GREEN LEDS ON INDICATES DEEPLY
DISCHARGED OR DEFECTIVE BATTERY PACK.
GREEN LED ON AFTER FAST CHARGING
CYCLE, INDICATES FULLY CHARGED
BATTERY PACK AND IN TRICKLE
CHARGE MODE.
Fig. 7
4-1/2 IN.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to
“CHARG
-
ING A COOL BATTERY PACK”
for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Sears Repair Center for
electrical check.