Filter
Top Products
4
Turning the power on/off
The power can be switched on by pressing the keys listed below.
To turn off the power, press
o
.
Key
o
m
d
t
u
s
y
Display status upon start-up
Restores the display as it was before the unit was switched off
(Resume function).
The main menu screen appears.
The input screen or menu screen of each dictionary appears (Direct-
on function)
Auto power off function
To save the battery, the PW-E500A will automatically turn its power off if no key
operations are detected for a set period of time. The activation interval initial setting
is 5 minutes, but it can be adjusted by following the directions on page 13.
To attach a commercially available strap
A carrying strap can be attached, as shown in the picture below (strap not
included).
Caution:
• Do not swing the unit by the strap, or use excessive
force to pull the strap. Doing so will cause a
malfunction or hardware damage to the unit.
Backlight
This product has a built-in backlight, which allows you to view the display and use
the product even in low-light conditions. Pressing
,
(Backlight) once illuminates
the display until you have not pressed any keys for approx. 1 minute or press
,
again.
Note:
• Use the backlight in low-light conditions. It will drain power from the operating
batteries and significantly reduce battery life.
• The backlight may remain on for less than 1 minute when
is displayed.
Key notation used in this manual
• All keys are framed (
A
, for instance); exceptions are found in the Calculator
section, where the numeral entries are shown with real numbers.
•Keys are often assigned with more than one function. The appropriate key/
function will be shown according to the input status.
<Example 1>
will be shown as either ‘
Q
’, ‘
1
’ or ‘1’ depending on the input status.
<Example 2>
will be shown as either ‘
G
’ or ‘
+
’ depending on the input status.
• The functions indicated with green typeface are second functions. Press and
release
^
, then press an appropriate key.
<Example 1>
^ l
directs to press and release
^
, then press
l
(
f
).
^ w
directs to press and release
^
, then press
w
(
<
).
Back of the unit