Filter
Top Products
-13-
M1014 7" x 12" Metal Cutting Bandsaw
SET UP
GET assistance when lifting this
machine. Otherwise, you can
severely injure yourself!
To install the handle, wheels, and feet, do these
steps:
1. With the help of an assistant, support the bandsaw
on wooden blocks approximately 4" from the ground
so you have room to install the handle, wheels, and
feet.
2. Align the handle mounting holes with the bandsaw
holes, and install the 5/16"-18 x 1-1/4" hex bolts,
washers, and nuts (see Figure 12).
3. Insert the axle into the cabinet, and slide the
wheels onto the axles.
4. Slide the two 5/8" flat washers onto the axles, and
install the two cotter pins (see Figure 13).
5. Thread one 3/8"-18 hex nut and install one 3/8"
washer onto each threaded foot shaft (see Figure
14).
6. Thread the foot shafts into the underside of the
bandsaw cabinet (see Figure 14).
7. With the help of an assistant, remove the bandsaw
from the blocks.
8. Turn the feet until the bandsaw is level, and tighten
the hex nut to lock the feet in place.
Handle, Wheels, and Feet
Figure 12. Installed handle.
Figure 13. Installed wheel.
Figure 14. Installed feet.
Hex Nut
Here
Flat
Washer
Here
Hex
Bolt and
Washer