Filter
Top Products
-17-
M1014 7" x 12" Metal Cutting Bandsaw
SET UP
Figure 24. Installing the table.
Figure 25. Installing the table support.
Figure 26. Checking table-to-blade
squareness.
4. Position and install the vertical cutting table with
the two stop plate mounting screws as shown in
Figure 24).
5. Use a 14 mm wrench to loosen the blade guide lock
bolt and install the table support as shown in Figure
25.
6. Place a machinist's square on the table as shown in
Figure 26, and make sure that the table and blade
are square with each other.
• If the table and blade are out of square, adjust
the table support bracket.