Filter
Top Products
ASSEMBLY
-18-
Table Insert
The Model W1686 is supplied with three differ-
ent sized table inserts. The inserts are designed
to reduce the gap between the spindle and the
table opening. The hole in each insert is oblong
to allow clearance when the table is in the tilt-
ed position.
To install the table insert:
1. Determine which table insert is best for the
particular spindle you are using.
2. Install the insert over the mounted spindle
and into the recessed hole on the table as
shown in Figure 13. The insert is fitted with
pins that allow it to fit into the table in only
one position. This ensures the table insert
will not make contact with the spindle even
when the table is tilted.
3. Adjust the setscrews shown in Figure 14 so
the top of the insert is flush with the table
surface.
NOTICE
Always use the table insert with the smallest
opening that still allows at least
1
⁄8" clear-
ance around the spindle.
Figure 13. The table insert should clear the
spindle by at least
1
⁄8" on all sides. Pins on
the underside of the insert ensure correct
positioning in the table.
Figure 14. Adjust the setscrews to position the
table insert flush with the table surface.