Filter
Top Products
ADJUSTMENTS
-20-
NOTICE
When tilting the table towards the back of
the machine, the positive stop bolt must be
removed completely. Be sure to recalibrate
the positive stop bolt whenever it is moved or
removed.
Figure 17. Use a machinist square to adjust
the table square to the spindle.
2. Using a machinist square, bring the table sur-
face square with the spindle surface as shown
in Figure 17.
3. Move the square to various points around the
table to ensure the table and spindle are
square on all sides.
4. Lock down both handles when you are satis-
fied with the position of the table.
5. Loosen the retainer screw (Figure 15) that
secures the scale pointer and adjust the scale
pointer to read 0˚. Re-tighten the retainer
screw.
6. With the table square to the spindle, adjust
the stop bolt until it just touches the under-
side of the table.
7. Retighten the jam nut to secure the positive
stop bolt.