-14-
W1677/W1711 10" Table Saw
SETUP
Your new table saw has been carefully packaged for safe
transporting. When u
npacking, remove the red shipping
braces that hold the saw to the pallet. If you notice the
machine has been damaged, please contact your autho
-
rized SHOP FOX
®
dealer immediately.
Unpacking
SETUP
The following is a description of the main components
shipped in the table saw box. Lay the components out
to inventory them.
Note: Some parts and hardware may
already be installed on the machine. Make sure to check
the machine when you use this inventory list.
Box Inventory (Figures
12 & 13) Qty
A. Saw Base Unit ..............................................1
B. Extension Wings ...........................................2
C. Cabinet Cover ..............................................1
D. Lock Knob ...................................................1
E. Handwheel ..................................................1
F. Miter Gauge ................................................1
G. Blade Guard/Splitter ......................................1
H. Dado Table Insert .........................................1
I. Standard Table Insert .....................................1
J. Dust Port ....................................................1
K. Arbor Wrench ..............................................1
L. Support Shaft ..............................................1
M. Blade Guard Brackets .....................................2
N. Handwheel Handle ........................................1
O. Switch Support Bracket ...................................1
Hardware and Tools Qty
• Flat Head Screw
5
⁄16"-18 x 1" (Switch Bracket) .......1
• Flat Washer
5
⁄16" (Switch Bracket) ......................1
• Hex Nut
5
⁄16"-18 (Switch Bracket) .......................1
• Tap Screws 10-24 x
3
⁄8" (Dust Port) ....................4
• Set Screws
5
⁄16"-18 x
3
⁄8" (Brackets on Shaft) .........2
• Hex Bolt
5
⁄16"-18 x 1
1
⁄2" (Brackets on Shaft) ..........2
• Flat Washers
5
⁄16" (Brackets on Shaft) .................4
• Lock Washers
5
⁄16" (Brackets on Shaft) .................2
• Hex Nuts
5
⁄16"-18 (Brackets on Shaft) ..................2
• Hex Bolts
5
⁄16"-18 x 1" (Guard/Splitter Install) .......2
• Flat Washers
5
⁄16" (Guard/Splitter Install) .............2
• Hex Wrenches 3, 4, 8mm .........................1 each
• Flat Wrench ................................................
1
Inventory
Figure 13. Table saw loose parts.
Figure 12. Saw base unit.
A
H
O
I
J
K
L
M
N
B
C
D
E
F
G