Filter
Top Products
-22-
W1677/W1711 10" Table Saw
SETUP
Before you test run the machine, do these steps:
1. Read all the warnings and directions regarding the
operation and controls of this machine.
2. Make sure the saw is stable.
3. Make sure the blade is mounted correctly and that
the arbor nut is tight.
4. Make sure the fence is parallel to the blade.
5. Make sure the guard assembly is installed, aligned
with the blade, and functional.
6. Make sure the saw blade does not touch the table
insert when it is adjusted to the maximum tilt angle
and height.
To test run the table saw, do these steps:
1. Connect the table saw to the power source.
2. Face the table saw and stand to the left of the
blade path.
3. Turn the table saw ON.
— The table saw should run smoothly with little or
no vibration; once it does, the machine is ready
for regular operations.
— Immediately turn the table saw
OFF if you suspect
any problems, and refer to
Page 48 to trouble-
shoot/fix any problems before starting the table
saw again. (If the source of an unusual noise or
vibration is not readily apparent, contact our
technical support for help
.)
Test Run
Projectiles thrown from the machine
could cause serious eye injury. Wear
safety glasses during assembly and
operation.
Loose hair and clothing could get
caught in machinery and cause serious
personal injury. Keep loose clothing
rolled up and long hair tied up and
away from machinery.