Filter
Top Products
-19-
W1677/W1711 10" Table Saw
SETUP
Figure 22. Installing handwheel, lock knob
and handle.
Figure 23. Installing dust port.
5. Mount the switch brace, as shown in Figure 21,
using the table mounting fasteners on the top end
and the switch mounting fasteners on the bottom
end.
Figure 21. Switch brace installed.
7. Mount the dust port onto the cabinet stand with the
four 10-24 x
3
⁄8" tap screws, as shown in Figure 23.
6. Install the handwheel over the threads, screw the
lock knob into the center, and attach the handle to
the handwheel, as shown in
Figure 22.
Figure 24. Motor shipping brace.
8. Remove the motor shipping brace, shown in Figure
24, then replace the fasteners that held the brace
back into the hole from which they came.