-21-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
Theairjetlocatedattheairforksendsastreamofair
across the air fork and into the air stream receiver (see
).Assoonasthesandingbeltobstructsthis
stream of air, a piston changes the direction of belt
movementtotheleft.Yourgoalistoadjustthisstream
of air so the system uses the least amount of air and yet
the machine still oscillates consistently.
.
Adjusttheairregulatorto70PSI.
Open both upper access doors on the sander, loosen
the sanding belt tension, and slide the belt so the
air stream is unobstructed.
Loosenthejamnutandturnthejetadjustment
knob () clockwise until the air stream is
reduced to a minimum.
Turnthejetadjustmentknobcounterclockwise,
and use a piece of cardboard to alternately block
and unblock the air stream until the upper drum
justbeginstoreactandmoveleftandright.
Turnthejetadjustmentknobcounterclockwisean
additional
1
⁄2turnandtightenthejamnut.
Complete on .
AirJetandairforkassembly.
AirStreamadjustmentknob.
AirStream
Receiver
AirFork
AirJet
AirStream
Adjustment
Knob
Lock
Lever
Height
Lever
Scale and
Pointer
The platen controls ( ) on your sander allow for
three basic types of sanding. The platen scale is
broken down in millimeter increments, and is for only
reduced-platen sanding depth positions. For aggressive
sanding, retract the platen to the Platen Up position,
adjust the table, and let the drums make the deep cut.
— The platen is above the level of the sanding
rollers, so the front roller removes large amounts of
material quickly, but leaves a rough finish.
— The platen is even with the sanding
rollers, so the rollers work together with the platen to
produce intermediate/final finishing.
— The platen is 2mm below the sanding
rollers, so the platen gives a smooth and feathered
finish.Avoidloweringtheplatenmorethan2MMbelow
the sanding belt rollers.
Platencontrols.