-31-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
One of four positioning wheels.
Positioning
wheel
The feed belt tension and tracking has been set at the
factory.However,adjustthefeedbelttensionand
tracking if you notice that your feed belt is slipping or is
tracking off center and loading up against the positioning
wheels () under the conveyor table, you must .
Turn the feed belt tension and tracking bolts equal
amountsfromside-to-sideandsetthebelttension
so it is snug and will not slip when sanding at a
maximum load.
Start the conveyor.
Turn the feed belt tension and tracking bolt to
position the feed belt roller evenly on each side.
See .
—If the conveyor tracks to the right, turn the right-side
tension and tracking bolt clockwise approximately in
1
⁄4 turn increments.
—Iftheconveyortrackstotheleft,turntheleft-side
tension and tracking bolt clockwise in approximately
1
⁄4 turn increments.
Run the feed belt for at least three minutes to
determine if the tracking is correct and the tension
stays the same.
Repeat steps as required to achieve the correct
tension and tracking.
Feed belt tension bolt.
Feed Belt
Tension and
Tracking Bolt