-26-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
The table stop switches prevent the table lift
motor from driving the table into the sanding drum.
Periodicallycheckandadjust(ifrequired)thetablestop
switches to protect the conveyor.
Supply air to the sander and tension the sanding
belt.
Pushthedownarrowkeyandlowerthetableuntil
you achieve six inches between the sanding drum
and the conveyor table surface (see ).
Loosenthemountingboltforthetable-downstop
switch and slide the switch so the switch plunger
depresses against the stop block and you hear the
switch click (see ).
Re-tightenthemountingbolt.
Pushtheuparrowkeyandraisethetableuntilyou
achieve an
1
⁄8 inch between the sanding drum and
the conveyor table surface.
Loosenthemountingboltforthetable-upstop
switch and move the switch so the switch plunger
depresses against the stop block and you hear the
switch click (see ).
Re-tightenthemountingbolt.
Use the up and down buttons to test the table
operation and make sure the switches shut the table
lift motor
OFF when the table is at the minimum
and maximum distance from the sanding drum.
Keypadtable-liftcontrols.
Tablestopswitchadjustment
locations.
Table Down
Stop Switch
Table Up
Stop Switch
Stop Block
Up and
Down
Key
Switch
Plungers
Mounting
Bolt
OFF