Filter
Top Products
-17-
W1752 Owner's Manual (Mfg. 1/07+)
The tool rest is equipped with a cam-action clamping
system to secure it to the lathe bed. When the lever is
engaged, a locking plate lifts up and secures the tool rest
base to the bed.
Loosen the release lever and slide the tool rest base
along the bed ().
Re-engage the release lever to lock the tool rest
base in place.
— If the release lever will not lock the tool rest base
onto the bed (either too loose or too tight), then
loosen or tighten the hex nut (located on the under-
side of the tool rest base) in small increments as
needed to achieve the proper clamping pressure.
Loosen the lock handles () and adjust the
tool rest vertically or swivel it as needed.
Tighten the lock handles.
. Tool rest controls.
Release Lever
Lock
Handle
Tool Rest
Base
Lock
Handle
The spur center installs into the headstock spindle with
a taper fit.
UNPLUG LATHE FROM POWER!
Insert the tapered end of the center into the spin-
dle, and push it in quickly and firmly (see
).
Check that the center is securely installed by giving
it a quick tug. (A properly installed center will not
pull out by hand.)
. Inserting spur center into
spindle.