Filter
Top Products
-8-
W1761/W1762 12" Table Saw with Riving Knife
SAFETY
Additional Safety for Table Saws
1. SAFETY GUARDS. Always use the blade guard, splitter, and anti-kickback fingers on ''through-saw-
ing'' operations. The blade cuts completely through the top of the workpiece on through-sawing
operations.
2. KICKBACK. Be familiar with kickback. Kickback happens when the workpiece is thrown towards
the operator at a high rate of speed. Until you have a clear understanding of kickback and how it
occurs, DO NOT operate this table saw!
3. REACHING OVER SAW BLADE. Never reach behind or over the blade while the saw is running;
hands or arms could be pulled into the saw blade if kickback occurs.
4. WORKPIECE CONTROL. Make sure the workpiece is stable on the table and is supported by the rip
fence or the miter gauge during cutting operations. DO NOT perform any cutting operations free-
hand.
5. SAFETY ACCESSORIES. Use push sticks, hold-downs, featherboards, and other devices to increase
cutting safety.
6. OPERATOR POSITION. Never stand or have any part of your body directly in-line with the cutting
path of the saw blade.
7. COMFORTABLE POSITION. Avoid operations and hand positions where a slip could cause your hand
to move into the blade.
8. CROSSCUTTING. Remove the rip fence whenever using the miter gauge to crosscut a workpiece.
9. CUT-OFF PIECES. Stop the blade before removing cut-off pieces.
10. BLADE HEIGHT. Always adjust the blade to the proper height above the workpiece.
11. WORKPIECE SUPPORT. Provide adequate support to the rear and sides of the saw table for wide
or long workpieces.
12. DAMAGED SAW BLADES. Never use blades that have been dropped or otherwise damaged.
13. DADOS AND RABBET OPERATIONS. Dado and rabbeting operations require special attention
because those operations must be performed with the blade guard removed. Be especially aware
of your personal safety whenever operating saw with the guard removed, and always immediately
replace the blade guard after these operations are complete.
READ and understand this
entire instruction manual
before using this machine.
Serious personal injury
may occur if safety and
operational information is
not understood and fol-
lowed. DO NOT risk your
safety by not reading!
USE this and other machinery with caution
and respect. Always consider safety first,
as it applies to your individual working
conditions. No list of safety guidelines can
be complete—every shop environment is
different. Failure to follow guidelines could
result in serious personal injury, damage
to equipment or poor work results.