Filter
Top Products
-19-
W1761/W1762 12" Table Saw with Riving Knife
SET UP
5. While an assistant holds the extension table, fasten
the 93" front rail to the extension table with three
M8-1.25 x 25 flat head screws, flat washers and hex
nuts (
Figure 16). Finger tighten for now.
6. Fasten the 79" rear rail to the extension table with
three M8-1.25 x 25 cap screws, lock washers, flat
washers, and hex nuts, as shown in
Figure 17.
Finger tighten for now.
7. Align the table and extension table with a straight-
edge (
Figure 18), then tighten the fasteners in
Figure 16 with a 5mm hex wrench and 13mm
wrench.
8. Repeat the leveling procedure and tighten the fas-
teners in
Figure 17 with a 6mm hex wrench and
13mm wrench.
9. Using a 17mm wrench, tighten the hex bolts shown
in Figure 15.
10. Thread a
3
/8-16 hex nut on each foot and thread the
feet into the bottom of the support legs as shown in
Figure 19.
Figure 16. Front rail/table fastener
locations.
Figure 17. Rear rail/table fastener
locations.
Figure 19. Foot installed on support leg.
Foot
Support Leg
Hex Nut
Figure 18. Leveling main extension table.