Filter
Top Products
-11-
W1772/W1773 37" Drum Sander
ELECTRICAL
ELECTRICAL
DO NOT work on your electrical system
if you are unsure about electrical
codes and wiring! Seek assistance from
a qualified electrician. Ignoring this
warning can cause electrocution, fire,
or machine damage.
W1772 Single-Phase 220V
Operation
The Model W1772 is wired for 220V single-phase opera-
tion.
This machine must be hardwired to a locking shutoff
switch (Figure
2) by a qualified electrician. Since hard-
wiring involves a permanent installation with conduit
runs, this task can only be safely accomplished by a quali
-
fied electrician. As always, observe all applicable electri
-
cal codes when connecting this machine to power.
This machine must be grounded! Verify the ground before
connecting this machine to the power source.
The machine must be properly set up before it is
safe to operate. DO NOT connect this machine to the
power source until instructed to do so in the "Power
Connection" portion of this manual.
W1772 Electrical
Specifications
Voltage Amp Draw Min. Circuit Size Connection Cord Extension Cord
220V 45.7A 60 Hardwire Conduit Setup N/A (Hardwire Only)
Figure 2. Locking shutoff switch.