Filter
Top Products
-14-
W1772/W1773 37" Drum Sander
SET UP
SETUP
The following is a description of the main components
shipped with the Model W1772/W1773. Lay the compo
-
nents out to inventory them.
Note:
If you can't find an item on this list, check the
mounting location on the machine or examine the pack
-
aging materials carefully
. Occasionally we pre-install cer-
tain components for safer shipping.
Box Inventory (Figure
6) Qty
A. Drum Sander ...............................................1
B. Control Panel ...............................................1
C. Handwheel ..................................................1
D. Top Cover ...................................................1
Tools (Not Shown)
—Hex Wrenches 4, 5mm ..............................1 Ea
—Wrenches 12/14 .........................................
1
—Phillips Head Screwdriver ..............................
1
—Spring Tension Tools ....................................
2
—Paper Retaining Clips ...................................
2
—Rubber Plates (Dust Scoop) ............................
2
Inventory
Disconnect power to the machine
before you do any assembly or adjust
-
ment tasks! Otherwise, serious per
-
sonal injury to you or others may
occur!
OFF
SUFFOCATION HAZARD!
Immediately discard all
plastic bags and pack
-
ing materials to elimi
-
nate choking/suffocation
hazards for children and
animals.
Figure 6. W1772/W1773 inventory.
A
B
C
D
This machine has been carefully packaged for safe trans-
portation. If you notice the machine has been damaged
during shipping, please contact your authorized Shop Fox
dealer immediately.
Unpacking
Items Needed for Setup
The following items are needed to complete the set up
process, but are not included with your machine
:
Description Qty
• Safety Glasses (for each person) ........................
1
• Power Lifting Equipment (forklift) .....................
1
• Lifting Straps (min. 2000 lb capacity) .................
2
• An Assistant ................................................1
• Power Cord (length as needed) .........................
1
• Power Disconnect Box ....................................
1
• Dust Collection System ...................................
1
• Dust Hoses
4" (length as needed) .......................4
• Hose Clamp
4" ..............................................4