Filter
Top Products
-16-
W1772/W1773 37" Drum Sander
SET UP
7. Remove the bolts, flat washers, and hex nuts from the
control panel support arm, as shown in Figure
10.
8. Remove the right access panel.
9. With assistance, lift the control panel into place and
secure it with the bolts, flat washers, and hex nuts
removed in Step
7.
10
. Reinstall the right access panel.
11
. Attach the brace from the control panel to the sander
as shown in Figure
11.
12. Place the handwheel over the shaft shown in Figure
12
and tighten the set screw in the handwheel hub.
Figure 11. Control panel brace.
Figure 10. Control panel mounting bolts.
Figure 12. Handwheel installed.