Filter
Top Products
-16-
W1816 Owner's Manual (Mfg. Since 10/09)
SETUP
11. Slide the four lower stand legs onto the leg
connectors, then connect them with (16)
3
⁄8"-16 x
3
⁄4" hex bolts and (16)
3
⁄8" flat washers, as shown in
Figure 16.
12. Attach the lower rear stand brace to two of the
lower stand legs with (2)
3
⁄8"-16 x
3
⁄4" hex bolts and
(2)
3
⁄8" flat washers, as shown in Figure 17.
Note: Choose which side of the machine you will
be rolling the collection drum away from to empty
it, then install this lower rear stand brace on the
opposite side.
13. Connect the two side stand braces to the lower
stand legs with (4)
3
⁄8"-16 x
3
⁄4" hex bolts and (4)
3
⁄8"
flat washers, as shown in Figure 18.
14. With the help from several other people, tip the
dust collector right-side-up onto the legs.
Figure 16. Lower stand leg attached to
the leg connector.
Connector
Lower
Stand Leg
x 16
Figure 17. Lower rear stand brace
attached to the lower stand legs.
Lower Rear
Stand Brace
x 2
Figure 18. Side stand braces attached.
Side
Braces
x 4