Filter
Top Products
-21-
W1816 Owner's Manual (Mfg. Since 10/09)
SETUP
26. Roll the collection drum underneath the cyclone
funnel, then connect the 9" clear flexible collection
hose between the funnel and the drum lid with the
two 9" hose clamps, as shown in Figure 29.
27. Connect the 1
1
⁄4" flexible vacuum hose between
the vacuum pipes of the funnel and the collection
drum with the two 1
1
⁄4" hose clamps, as shown in
Figure 29.
28. Remove the bag clamps from the bottom of the
canisters, position the plastic canister bags around
the canister bottoms, then secure them with the bag
clamps, as shown in Figure 30.
Note: To make this process easier, use tape to hold
the bags in place before securing them with the
clamps, as shown in Figure 30.
Congratulations! You have completed the assembly of your
new cyclone dust collector. Next, successfully perform the
Test Run procedure as instructed in the next subsection
before placing this machine into operation.
Figure 29. Collection and vacuum hoses
installed.
Collection
Hose
Vacuum
Hose
Figure 30. Canister bag installed.
Bag Clamp
Tape