Filter
Top Products
To avoid injury, do not use a blade larger or smaller than 4-
3/8" diameter and 3/4" arbor.
8. Install the blade collar in the proper orientation, then
install blade bolt. Tighten blade bolt finger tight. Press
the arbor lock and tighten blade bolt securely, but do not
overtighten.
9. Be sure the arbor lock is released so the blade turns
freely.
10.Close blade bolt cover, insert rear screw, and tighten.
After installing a new blade, check for any contact with the
base or table structure. If blade contacts table, seek
authorized service.
$5B5:3:521853:91:@
See figures 6-7.
Disconnect plug from power source
before performing any assembly,
adjustment or repair to avoid possible injury.
1. Remove the anti-kickback pawls.
2. Using a philips screwdriver, slightly loosen the two
screws which mount the riving knife to the blade guard.
3. Align the riving knife in line with the blade.
4. Re-tighten both riving knife screws.
FIG. 6
FIG. 7
$5B5:3
:521
%/>1C?
$5B5:3:521
853:
$5B5:3
:521C5@4
8-01
8-01;8@
::1>;88->
!A@1>;88->
8-01
??19.8E-:006A?@91:@?
WARNING
!