Filter
Top Products
-5:@1:-:/1
For your own safety, turn all switchs
“OFF” and remove plug from power
source outlet be fore maintaining or lubricating your saw.
Do not allow sawdust to accumulate inside the saw. Fre -
quently blow out any dust that may accumulate inside the
saw cabinet and the motor. Clean your cutting tools with a
Gum and Pitch Remover.
The cord and the tool should be wiped with a dry clean
cloth to prevent deterioration from oil and grease.
Certain cleaning agents and solvents
can damage plastic parts. Some of these
are: gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents which contain
am monia. Avoiding use of these and other types of cleaning
agents will minimize the possibility of damage.
A coat of automobile-type wax applied to the table will help
to keep the surface clean and allow workpieces to slide
more freely.
I
f the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
Make sure the teeth of the anti-kickback pawls are al ways
sharp. To sharpen: remove anti-kickback pawls from the
s
aw and sharpen the teeth using a small file (Smooth Cut).
A
ll repairs, electrical or mechanical,
should be attempted only by trained
repairmen. Contact the nearest Factory Service Center or
Authorized Service Station or other competent repair
s
ervice. Use only identical replacement parts, any other
may create a hazard.
//1??;>51?
Use only recommended accessories.
Follow instructions that accompany
accessories. Use of improper accessories may cause
hazards.
-5:@-5:5:3+;A>8;;>5:3%-C
&>;A.81?4;;@5:3
&A>:?C5@/4H!I-:0-8C-E?>19;B1<8A32>;9@41<;C1>?;A>/1.12;>1@>;A.81?4;;@5:3
&$!' "$! $+
)588:;@?@->@
Power cord is not plugged in. Plug in.
Fuse or circuit breaker tripped. Replace fuse or reset tripped circuit breaker.
Cord damaged.
Have cord replaced by an Authorized Skil Service Center
or Service Station.
Trigger switch will not work.
Saw assembly lock knob is engaged or bump switch (ripping
mode power switch) is in ON position. See page 16.
Burned out switch.
Have switch replaced by an Authorized Skil Service Center
or Service Station.
;1?:;@/;91
A<@;?<110
Extension cord too light or too long. Replace with adequate cord.
Low house voltage. Contact your electric company.
D/1??5B1B5.>-@5;:
Blade out of balance. Discard Blade and use different blade, see page 13.
Saw not mounted securely to stand or
workbench.
Tighten all mounting hardware.
Blade bolt not tight. See “Blade Removal and Installation”, page 13.
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!