Filter
Top Products
1 –Pump 9-Station Controller Chapter 3: Installation 20 of 38
Entering Values Into Controller Fields
When it is necessary to change the settings for a particular feature, you will need to do the
following:
1. Use the arrow keys to select the value.
2. Select the value in the field to be changed by pressing the SET key.
3. Press the numbers you want to enter into the field from the numeric keypad (Shown
below).
4. Press the green ENT (Enter) key to enter those values or the red ESC (Escape) key to
return the values back to their original setting.
5. Use the arrow keys to scroll up or down to set the values in the next or previous field.
Note: Values entered into the fields must be set into the controller using the ENT key
before moving on to the next field or data will be lost.
Figure 7: Controller Keypad