Filter
Top Products
1 –Pump 9-Station Controller Chapter 3: Installation 24 of 38
Second Pump Setup Screen
Once the settings have been entered into the initial Pump Setup Screen, press F3 to access the
next set of configurable pump settings. The second pump setup screen (Figure 11) will be
shown.
Figure 11: Second Pump Setup Screen
This screen will allow you to set the following features:
• CLEAN PULSES – This is the number of blowback/implosion pulses allowed during
filter cleaning. This value can be set between 1 and 99.
• ON PULSE- This feature allows you to set the amount of time that the
blowback/implosion pulse will remain on during filter cleaning. This value can be set
between 0.1 and 99.9 seconds.
• OFF PULSE- This feature allows you to set the amount of time in between
blowback/implosion pulses during filter cleaning. This value can be set between 0.1
and 99.9 seconds.
Once the values have been entered for the settings listed above, the operator can choose to do
the following:
• Turn the pump On or Off (Press F1 while in this screen)
• Enter additional values for this pump in the third setup screen (Press F3).
• Return to the Main Menu (Press F6).