Filter
Top Products
1 –Pump 9-Station Controller Chapter 3: Installation 27 of 38
Second System Setup Screen
Once the settings have been entered into the initial System Setup Screen, press F3 to access
the next set of configurable system settings. The second system setup screen (Figure 14) will
be shown.
Figure 14: Second System Setup Screen
This screen will allow you to set the following feature:
• Station Demand Debounce- This is the minimum amount of time in seconds before the
demand signal is recognized by the system. Values can be set between 0.5 and 2.0.
Once the values have been entered for the settings listed above, the operator can choose to do
the following:
• Press the F5 key once while in this screen to view and set the Debounce settings for
Stations 4-6. If the F5 key is pressed again while in the Debounce settings for Stations
4-6, the screen will display and allow the operator to set the Debounce settings for
Stations 7-9.
• Return to the Main Menu (Press F6).
Third System Setup Screen
Once the Debounce settings have been entered into the second System Setup Screen, press F3
to access the next system setting. The third (really the fifth) system setup screen (Figure 15)
will be shown.
Figure 15: Third System Setup Screen
This screen will allow you to set the Alarm Silence Duration. This feature is the length of
time (in minutes) before an alarm horn will reactivate while in an alarm condition. The value
can be set between 1 and 50.
Once the value has been entered for the setting listed above, the operator can choose to do the
following:
• Return to the Initial System Setup Screen (Press F5).
• Return to the Main Menu (Press F6).