Filter
Top Products
TDS Family Oscilloscope Programmer Manual
D–1
Appendix D: Factory Initialization Settings
The factory initialization settings provide you a known state for the digitizing
oscilloscope.
Factory initialization sets values as shown in Table D–1.
Table D–1: Factory Initialization Settings
Control Changed by Factory Init to
Acquire mode Sample
Acquire repetitive signal TDS 400A, 510A, 500C, & 700C: ON
(Enable ET)
Acquire stop after RUN/STOP button only
Acquire # of averages 16
Acquire # of envelopes 10
Channel selection Channel 1 on, all others off
Cursor H Bar 1 position 10% of graticule height
(–3.2 divs from the center)
Cursor H Bar 2 position 90% of the graticule height
(+3.2 divs from the center)
Cursor V Bar 1 position 10% of the record length
Cursor V Bar 2 position 90% of the record length
Cursor amplitude units Base
Cursor function Off
Cursor mode Independent
Cursor time units Seconds
Date and time No change
Delay events,
triggerable after main
TDS 400A: 1
TDS 510A, 500C, 600B, & 700C: 2
Delay time,
delayed runs after main
TDS 400A: 10 ns
TDS 510A, 500C, 600B, & 700C: 16 ns
Delay time,
delayed triggerable after main
TDS 400A: 60 ns
TDS 510A, 500C, 600B, & 700C: 16 ns
Delay trigger average # 16
Delay trigger envelope # 10
Delayed, delay by ... Delay by Time