Filter
Top Products
English
Purging and Priming for Solvent-Based Paint
Thorough cleaning is not necessary when using solvent-based
paint. All you need to do is purge the test fluid from the
system.
1. Secure the return hose into a waste container.
2. Place a full container of paint under the suction tube.
3. Turn the pressure control knob fully counterclockwise to
reduce the pressure to its lowest setting.
4. Set the PRIME/SPRAY
valve to PRIME.
5. Turn the ON/OFF switch
to ON.
6. Slowly turn the pressure
control knob clockwise to
increase the pressure until
fluid starts to come out of
the return hose. Use only
enough pressure to keep
the fluid coming out.
7. Turn the pressure control knob fully counterclockwise to
its lowest setting when the test fluid is purged and paint is
coming out of the return hose.
8. Remove the return hose from the waste container and
place it in its operating position above the container of
solvent-based paint.
9. Keep circulating the paint through the system until the
paint coming out of the return hose is free of air bubbles.
10. Turn the pressure control knob fully counterclockwise to
its lowest setting.
The pump is now purged. Skip to Purging and Priming the
Spray Hose.
Purging and Priming the Spray Hose
After the pump is purged and primed, you must do the same
for the spray hose.
If a metal container is used, ground the
gun by holding it against the edge of
the container while flushing. Failure to
do so may lead to a static electric
discharge which may cause a fire.
1. Turn the pressure
control knob fully
counterclockwise to its
lowest setting.
2. Set the PRIME/SPRAY
knob to SPRAY.
3. Unlock the spray gun.
4. Turn the pressure
control knob slowly clockwise to increase pressure.
5. Trigger the gun into a waste container until all air, water or
solvent is purged from the spray hose and paint is flowing
freely.
6. Turn the pressure control knob fully counterclockwise to
its lowest setting.
7. Set the PRIME/SPRAY knob to PRIME and trigger the gun
into the waste container to be sure that no pressure is left
in the hose.
8. Lock the spray gun trigger lock.
Pressure Control Knob
WARNING
NOTE: Make certain that the spray gun has no tip
installed.
PRIME/SPRAY
Valve
Operating the Spray Gun
POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is
in either the spray or the unclog position. Always engage
the gun trigger lock before removing, replacing or
cleaning tip.
Pressure Relief Procedure
Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for cleanup.
1. Lock the gun by turning the gun trigger lock to the locked
position.
2. Turn the motor off.
3. Turn the pressure
control knob
counterclockwise to its
lowest setting.
4. Turn the PRIME/SPRAY
knob to PRIME.
5. Unlock the gun by
turning the gun trigger lock to the unlocked position.
6. Hold the metal part of the gun firmly to
the side of a metal container to ground
the gun and avoid a build up of static
electricity.
7. Trigger the gun to remove any
pressure which may still be in the
hose.
8. Lock the gun by turning the gun trigger lock to the locked
position.
POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is
in either the spray or the unclog position. Always engage
the gun trigger lock before removing, replacing or
cleaning tip.
WARNING
Pressure Control Knob
WARNING
WARNING
© SprayTECH Corporation. All rights reserved. 5