Filter
Top Products
32
OPERATING MANUAL
VERSION 12/2012 ORDER NUMBER DOC 2330426
6.5 COMMISSIONING
Every time before starting up the following points should be observed as laid down in
the operating instructions:
- Observe all safety regulations in accordance with chapter 4.
- Carry out commissioning properly.
6.5.1 SAFETY REGULATIONS
Emergency stop
In the case of unforeseen occurrences close the air cut-o valve immediately and open the
return valve (if installed) and/or delivery devices (valves or guns).
High pressure spray jet!
Danger to life from injecting paint or solvent.
Never reach into the spray jet.
Never point the spray gun at people.
Consult a doctor immediately in the event of skin injuries caused
by paint or solvent. Inform the doctor about the paint or solvent
used.
Never seal defective high pressure parts, instead relieve the
pressure from them and replace them.
WARNING
Toxic and/or ammable vapor mixtures!
Risk of poisoning and burns.
Operate the unit in a spray booth approved for the working
materials.
-or-
Operate the unit on an appropriate spraying wall with the
ventilation (extraction) switched on.
Observe national and local regulations for the outgoing air
speed.
WARNING
Gas mixtures can explode if there is an incompletely filled pump!
Danger to life from flying parts.
Ensure that the pump and suction system are always completely
filled with cleaning agent or working medium.
Do not spray the unit empty after cleaning.
WARNING