Filter
Top Products
27
GM 5000EAC.
milli Pascal x
Sec mPas
Centipoise Poise DIN Cup
4 mm ; 0.16 inch
Ford Cup 4 Zahn 2
10 10 0.1 5 16
15 15 0.15 8 17
20 20 0.2 10 18
25 25 0.25 14 12 19
30 30 0.3 15 14 20
40 40 0.4 17 18 22
50 50 0.5 19 22 24
60 60 0.6 21 26 27
70 70 0.7 23 28 30
80 80 0.8 25 31 34
90 90 0.9 28 32 37
100 100 1 30 34 41
120 120 1.2 33 41 49
140 140 1.4 37 45 58
160 160 1.6 43 50 66
180 180 1.8 46 54 74
200 200 2 49 58 82
220 220 2.2 52 62
240 240 2.4 56 65
260 260 2.6 62 68
280 280 2.8 65 70
300 300 3 70 74
320 320 3.2
340 340 3.4
360 360 3.6 80
380 380 3.8
400 400 4 90
OPERATING MANUAL
EDITION 03/2012 PART NUMBER DOC 2319150
5.2 PREPARATION OF PAINTS
The viscosity of the paints is of great importance. The best spraying results are obtained
with values between 25 and 40 DIN-s (measured in immersion fl ow cup DIN 4 mm;
0.16 inches). Processing of up to 60 DIN-s is generally possible without problem, if high
coating thicknesses are required.
The Wagner AirCoat fl at jet spraying process determined optimally the different viscosity
of the paint by two air cap types. These can be found in the Accessories.
In the case of application problems contact the paint producer.
5.2.1 VISCOSITY CONVERSION TABLE