Filter
Top Products
Windows CE Driver
Printer Settings
12
P1055866-001 TTP 2030™ Windows CE Software Integrator Guide 4/14/2013
• OK – applies the settings and exits the program
• Cancel – does not apply the settings and exits the program
• Apply – applies the settings but does not exit the program
• Default – sets all settings to factory default
The following parameter settings are sent to the printer during each print job.
Media Width
The media width can be set to 58 mm, 60 mm, 80 mm and 82.5 mm. The default setting is
80 mm.
Media Height
The media height can be set between the minimum page length of 90 mm and the maximum
page length of 600 mm. The default setting is 150 mm.
Darkness
The Darkness can be set between 1 and 15 with 1 being the lightest. The default setting
is 9.
Max Print Speed
The max print speed can be set between 47 mm and 150 mm per second (mm/s). The default
setting is 150 mm/s. The actual print speed may vary depending on the darkness and the
content printed.
Media Tracking Continuous, Variable Length,
Mark Sensing
Variable Length
Top Margin (mm) 2 mm to 10 mm 10 mm
Bottom Margin (mm) 0 to 9 mm 0
Cutter Mode None, Every Page, End of
Document
Every Page
Partial Cut Width 0, 10 mm to 60 mm 0
Presenter Loop Length 0 to 600 mm 416 mm
Eject Length 20 mm to 600 mm 50 mm
Present Length Addition 0 to 255 mm 0
Presenter Timeout 0 to 300 seconds 0
Clear Presenter Disable, Enable Disable
Presenter Mode Eject, Retract Eject
Table 3 • Parameter Settings and Defaults
Parameter Value Range Default Value